Sanwa Gemini X Spécifications télécharger pdf (Page 8)

Page 8

 The Auxiliary Switch controls different options, depending on your programming preferences. In

the default conguration, the Auxiliary Switch controls Auxiliary Channel 3. In addition, the Auxiliary Switch is used to program

and control the different Mixes that are available.

 Houses the 4 'AA' Alkaline cells that power the transmitter.

 Used in the process of Binding the transmitter and receiver.

 Used for onboard charging of the optional Ni-Cd or Ni-MH batteries. For more information, see page 9.

 The portion of the antenna that extends the Antenna Reception Wire. The Coaxial Cable can be bent into gentle

curves, however, do not bend the Coaxial Cable acutely, or repeatedly bend it, or the antenna core can be damaged. The Coaxial

Cable should be installed through a nylon tube (antenna tube) in the vertical position for the best reception.

 The Handle provides a comfortable way to carry your transmitter. It also provides a comfortable angle to program the

transmitter when the transmitter is laid on its back on a at surface.

 The heart of the programming and display features of the transmitter. All programming and transmitter

display functions are shown on the Multi-Function LCD.

 Used to attach your neck strap (available separately) to the transmitter.

 Flashes slowly when the transmitter is turned ON and transmitting a signal. Flashes in rapid succession

indicating that Mixing is Active. The Power Indicator Light is also used during the Binding process.

 Turns the transmitter ON and OFF.

 Controls the steering function of your model. The Steering Control Stick spring tension is adjustable to

suit your preference. For more information, see the Control Stick Spring Tension Adjustment section below.

 Used to adjust the center trim of the steering servo.

 Controls the Throttle and Brake (if equipped) functions of your model. The Throttle Control Stick spring

tension is adjustable to suit your preference. For more information, see the Control Stick Spring Tension Adjustment section below.

 Used to adjust the center trim of the throttle servo.

 The Programming Keys are used to facilitate transmitter programming. The four Programming Keys

consist of two MENU Keys (Right and Left), one +/INC (Increase) Key, and one DEC/- (Decrease) Key.

 The TRM Switch controls different options, depending on your programming preferences. In the

default conguration, the TRM Switch controls the Steering Dual Rate adjustment. The TRM Switch can also control Throttle High

EPA, Throttle Brake EPA, Auxiliary Channel 3 High EPA, Auxiliary Channel 3 Low EPA, and more.

 The two Toggle Switches perform the same functions as the four Programming Keys. The Toggle

Switches make it easy to make programming changes during use. For example, to change the Steering Dual Rate percentage value

or Activate the Dig and Burn functions while your driving. For more information, see page 11.

FEaTURES FaMiLiaRizaTiOn

FEaTURES DEScRiPTiOnS, cOnTinUED....

cOnTROL STick SPRing TEnSiOn aDjUSTMEnT

The spring tension of the control sticks can be adjusted to suit your preference. Some

drivers prefer a rmer feel and some drivers prefer a softer feel.

1) Remove the battery cover on the back of the transmitter by pushing down rmly on

the two tabs in the top of the battery cover and pulling the battery cover out.

2) Unplug the battery from the transmitter and remove it. Set the battery aside for now.

3) Remove the eight Phillips head screws from the back of the transmitter, then very

carefully pull the back half of the transmitter off.

Pull the back half of the transmitter straight off to avoid bending or damaging the

battery pins.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Sanwa Gemini X Spécifications Page 8

Commentaires sur ces manuels